We’d like to explain you how to change the freezer door gasket on the refrigerator. Before we attempt this repair, we’ll carefully inspect the new door gasket to make sure there are no deformities, cuts, or tears in the gasket material. If everything looks good on that, then we’ll go ahead and do the repair.
Today, we’re to change the drive motor on your dryer. Drive motor is used to power the blower as well as turn the tumbler. It’s a really easy job to change, and let me show you how we do it. Now, to do this repair, since we will be working near some electrical circuits, first thing we need to do is to disconnect power to the dryer. Either unplug it or locate the electrical panel, turn off the appropriate breaker or remove the appropriate fuses. Once we’ve done that, we’ll need to pull the dryer, just slightly forward, so that we can access screws that are just underneath the main top at the back.
Today we are going to to change the door handle on your range and it’s a really easy job, all you are going to need is a Phillips screw driver, let me show you how we do it. Now to do this repair we will need to remove the door from the range which is a simple procedure, we’ll just open the door fully and there are some hinge stops that are located right where the hinge goes into the opening to the oven and just pry those outward till they are fully extended, and we can close the door until it comes to a stop and at that point we are lift the whole door and the hinges right out of the range, and then we can set it on a suitable work surface so that we can change the handle.
Today we’d like to show you how to change the surface element on your smooth top range. It’s a really easy job. All we’re going to need is a number two Phillips screw driver and maybe a pair of needle nose pliers. Let me show you how we do it because we’re going to be working near some electrical circuits.
Hello, my idea of white friends out there on the Internet. Hey Jeff, here again and today we have a video that we’re going to show you how to install a dishwasher and we’re going to show you how to do it right so that you don’t violate your building codes at the same time. So let’s get right into it. So we’re looking at the side of the dishwasher.
